Skip to product information
1 of 2


USA American Flag 3-Layer Red Line Rubicon Mojave Blackout Decal- Fits Jeep Wrangler & Gladiator JL Fender Vent Decal-Pair

Regular price $49.00
Regular price Sale price $49.00

USA American Flag 3-Layer red line decal cut to fit inside the 2018 & newer Jeep Wrangler JL and 2020 and newer Jeep Gladiator fender vent.

Measures approximately 15" x 9.5".

Matte black background, gloss black topographic lines with gloss red. Decals are cut sent separately, for you to align. Apply red using the wet method first, then after dry, apply black decal using wet method. Red is a full sized vent decal, matte black is slightly smaller and applied on top of red. Gloss black design will be applied on top of matte black.

Decal order comes as a pair- (1) driver side, (1) passenger side.

"Dark red" is closest to Rubicon red
"Orange" is closest to Mojave orange- It is slightly off, but fairly close. Message with any questions

"Light Blue" is  closest to 4xE blue (non metallic).

Colors may be slightly off from factory colors- please contact us with any questions

Customer Reviews

Based on 6 reviews
Jin W Soung
L&B decals are awesome

Looking slick ,fitments are perfect and quality is top.
There few small bubbles but don't worry, it goes away.
Highly recommend.

Jonathan Paige
3rd layer nightmare

Received 2nd shipment to replace defective 3rd layer (star layer) had major issues with backing not releasing from the Stars and Stripes. Feel like I wasted my money with nothing to show for it. Was very hopeful. Layer 1 and 2 went on nicely but all messed up by 3rd layer issues.

monica preston
Decal layers

I like how it turned out but wish it came in one piece and not three. Luckily my window tint people applied it and not me!

Linda lewis

no customer service

Lance Liddell
USA Flag 3 Layer Red Line Rubicon

I received my flag decal a few weeks ago and had to wait for the weather to warm up in order to do the install. The instruction said it needed to be over 60°. That day Finally came and it was almost 70°, so I went for the install. I followed the instructions on removing the air bubbles and excess water. I waited the recommended hour in between applying each layer. The Stars and Stripes where the hardest to apply. The backing was stickier than the actual vinyl stripes. So getting the stripe to separate and stick to the flat black layer took a lot of time. 5 hours later it was done. I thought it turned out pretty good. The next day the temp was higher around 75. When I came out to look it over the black layers had several small bubbles/blisters from the heat. When I tried to push the bubble out to edges it just made things worse. Are there anything recommendations for fixing this issue?